Everything below concerns Chromatogram. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-03-24. Where a claim depends on a specific study, the study is described rather than over-claimed.
Laboratories apply HPLC testing across pharmaceutical, food, environmental, and industrial chemistry. The method can measure active ingredients, impurities, additives, preservatives, and degradation products. Sample preparation often includes dilution, filtration, and sometimes extraction or derivatization. The choice of column, mobile phase, pH, temperature, and detector depends on the analytes and matrix. Results are compared with reference standards to assign identity and concentration. Method suitability is judged by resolution, precision, and accuracy.
HPLC testing is not a single fixed procedure; it is a family of separation modes. Reversed-phase, normal-phase, ion-exchange, size-exclusion, and affinity chromatography each suit different analyte properties. Reversed-phase methods dominate because they handle many neutral and moderately polar compounds. Detection can be optical, electrochemical, or mass spectrometric, and the detector dictates what information is available. Coupling with mass spectrometry increases selectivity and enables identification when standards are unavailable. The technique cannot separate every mixture without adjustment.
Routine HPLC testing depends on controlled reagents, calibrated instruments, and documented procedures. Columns degrade over time, so retention times and peak shapes are monitored for drift. Mobile phases are filtered and degassed to prevent pump damage and detector noise. Reference standards must be traceable and stored under suitable conditions. Data handling systems record injections, calculations, and audit trails. Quality control samples interspersed with unknowns help detect errors during a run.
Developing an HPLC method begins with defining the purpose, such as quantifying a main component, measuring impurities, or confirming identity. Analysts select separation mode, column, mobile phase, detection, and sample preparation based on analyte properties and matrix. Experiments vary solvent strength, pH, buffer type, and temperature to achieve resolution between critical peaks. The goal is a robust method that produces reliable results across instruments and operators. Method development often involves trial runs and statistical optimization.
Validation demonstrates that a method is suitable for its intended use. Typical performance characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulators and standards organizations provide frameworks, but specific requirements depend on the application and jurisdiction. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, retention time repeatability, and sensitivity. A validated method is not permanently fixed; changes may require partial or full revalidation.
| Property | Value | Notes |
|---|---|---|
| Abbreviation | HPLC | Also called high-performance liquid chromatography |
| Separation mechanism | Differential partitioning | Compounds distribute between mobile and stationary phases |
| Typical column chemistry | C18 (octadecylsilane) | Used in reversed-phase separations |
| Typical detector | UV-Vis or photodiode array | Mass spectrometry is common for trace and confirmatory work |
| Typical particle size | 1.8–5 µm | Smaller particles require higher pressure and can improve speed |
Most routine HPLC testing uses reversed-phase columns, where the stationary phase is nonpolar and the mobile phase is a polar mixture such as water with an organic solvent. Analytes partition between the two phases according to polarity, size, and charge. Gradients that change solvent composition over time can separate compounds with broad retention ranges. Isocratic conditions keep solvent composition constant and suit simpler mixtures. The choice of column chemistry, pH, and temperature affects selectivity and peak shape.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. UV detection is widely used because many organic compounds absorb light, but it requires a chromophore. Mass spectrometry provides mass-based identification and high sensitivity for trace analytes. Each detector has trade-offs in selectivity, cost, and compatibility with mobile phases. Quantification typically uses calibration curves prepared from reference standards. Results are reported as concentration, purity, or presence above a limit.
In quality control laboratories, HPLC testing supports batch release, raw material checks, stability studies, and impurity profiling. A validated method defines sample preparation, instrument settings, calibration, and acceptance criteria. Analysts compare results with specifications and investigate out-of-specification outcomes before a batch is approved. Documentation includes chromatograms, integration records, audit trails, and reagent details. Because results influence product decisions, laboratories follow formal quality systems and data integrity rules. The exact tests and limits depend on the material, its intended use, and the applicable regulatory framework.
Method validation examines whether an HPLC procedure is suitable for its intended purpose. Common parameters include accuracy, precision, specificity, linearity, range, detection limit, quantification limit, and robustness. Accuracy describes closeness to a true or accepted value, while precision describes agreement among repeated measurements. Specificity shows whether the method can measure the analyte without interference from related substances. Robustness tests small deliberate changes in flow, temperature, or solvent composition. Validation is not a one-time event; methods may need partial revalidation after changes to instruments, columns, sample handling, or specification limits. Regulatory guidance provides frameworks, but some details remain method-specific.
== Selected publications == Armon, A., Graur, D., & Ben-Tal, N. (2001). ConSurf: An algorithmic tool for the identification of functional regions in proteins by surface-mapping of phylogenetic information. Journal of Molecular Biology, 307, 447–463. Glaser, F., Pupko, T., Paz, I., Bell, R. E., Bechor-Shental, D., Martz, E., & Ben-Tal, N. (2003). ConSurf: Identification of functional regions in proteins by surface-mapping of phylogenetic information. Bioinformatics, 19, 163–164. Pupko, T., Bell, R. E., Mayrose, I., Glaser, F., & Ben-Tal, N. (2002). Rate4Site: An algorithmic tool for the identification of functional regions in proteins by surface mapping of evolutionary determinants within their homologues. Bioinformatics, 18, S71–S77. Ashkenazy, H., Abadi, S., Martz, E., Chay, O., Mayrose, I., Pupko, T., & Ben-Tal, N. (2016). ConSurf 2016: An improved methodology to estimate and visualize evolutionary conservation in macromolecules. Nucleic Acids Research, 44, W344–W350. Rubin, M., & Ben-Tal, N. (2021). Using ConSurf to detect functionally important regions in RNA. Current Protocols, 1, e270. Ben-Tal, N., & Kessel, A. (2010). Introduction to Proteins: Structure, Function, and Motion. Ezerzer, Y., Frenkel-Pinter, M., Kolodny, R., & Ben-Tal, N. (2025). A building blocks perspective on protein emergence and evolution. Current Opinion in Structural Biology, 91, 102996. Yariv, B., Yariv, E., Kessel, A., Masrati, G., Ben Chorin, A., Martz, E., Mayrose, I., Pupko, T., & Ben-Tal, N. (2023). Using evolutionary data to make sense of macromolecules with a “face-lifted” ConSurf.
Following the invasion, it formed part of Task Force Black/Knight to combat the post invasion insurgency; in late 2005/early 2006, the SAS were integrated into JSOC and focused its counterinsurgency efforts on combating al-Qaeda in Iraq and the Sunni insurgency alongside Delta Force. The counter-insurgency was successful, and the UKSF mission in Iraq ended in May 2009. Overall, more than 3,500 terrorists were "taken off the streets" of Baghdad by 22 SAS. Various British newspapers have speculated on SAS involvement in Operation Ellamy and the 2011 Libyan civil war. The Daily Telegraph reports that "defence sources have confirmed that the SAS has been in Libya for several weeks, and played a key role in coordinating the fall of Tripoli." While The Guardian reports "They have been acting as forward air controllers – directing pilots to targets – and communicating with NATO operational commanders. They have also been advising rebels on tactics." Members of the Special Air Service were deployed to Northern Iraq in late August 2014, and according to former SIS chief Richard Barrett, would also be sent to Syria, tasked with trying to track down the Islamic State of Iraq and the Levant (ISIL) terrorist group that the press labelled the Beatles. Since the 1990s SAS officers have risen to senior appointments in the British Armed Forces. General Peter de la Billière was the commander in chief of the British forces in the 1990 Gulf War. General Michael Rose became commander of the United Nations Protection Force in Bosnia in 1994.
== Pathology == The interaction of GPX4 with the autophagic degradation pathway further modulates cell's response to oxidative stress. Impaired GPX4 function plays a role in tumorigenesis, neurodegeneration, infertility, inflammation, immune disorders, and ischemia-reperfusion injury. Additionally, the R152H mutation in GPX4 is involved in the development of Sedaghatian-type spinal metaphyseal dysplasia, a rare and fatal disease in newborn babies.
Finasteride, also known as 17β-(N-tert-butylcarbamoyl)-4-aza-5α-androst-1-en-3-one, is a synthetic androstane steroid and 4-azasteroid. It is an analogue of androgen steroid hormones like testosterone and DHT. As an unconjugated steroid, finasteride is a highly lipophilic compound.
=== Mutation === IDH1 mutations are heterozygous, typically involving an amino acid substitution in the active site of the enzyme in codon 132. These mutations are somatic, meaning they primarily occur in cells that can become cancerous, such as those in brain and bone tumors. The mutation results in a loss of normal enzymatic function and the abnormal production of 2-hydroxyglutarate (2-HG). It has been considered to take place due to a change in the binding site of the enzyme. 2-HG has been found to inhibit enzymatic function of many alpha-ketoglutarate dependent dioxygenases, including histone and DNA demethylases, causing widespread changes in histone and DNA methylation and potentially promoting tumorigenesis.
Sources: en.wikipedia.org
==== Nuclear power ==== There were three nuclear power plants in Schleswig-Holstein: Krümmel, Brunsbüttel, and Brokdorf. The last operating plant in Schleswig-Holstein, the Brokdorf-plant was shut down on new-years eve 2021. There is also a nuclear research center known "Helmholtz-Zentrum Geesthacht" (rebranded as Hereon) with 2 research reactors, located right next to the Krümmel plant. During the 1990s, ten more cases of leukemia among children than were expected were identified in Elbmarsch, near the Krümmel plant. Anti-nuclear activists believed it was due to the nuclear plant, which led to several investigations. The reported discovery of small spherical beads of nuclear material in the area led to further concern, as well as the presence of minute amounts of plutonium in the Elbe. The origins of the nuclear material were disputed, with one report determining them not to be that of the Krümmel plant. Another report claimed that they may have come from an undisclosed fire in 1986, however, this theory has been questioned as it would have required a substantial government cover-up. The Chernobyl disaster has also been suggested as a source, though it is considered unlikely. The probable source of the material, especially in the Elbe, is nuclear reprocessing plants in France. A 2010 report exonerated the nuclear power plants on the Elbe as the cause of contamination. Further doubt was cast on the nature of the supposed beads of nuclear material, with a Federal commission chastising the original commission that claimed to have discovered the beads.
==== July 2017 norovirus ==== Despite corrective actions, the company faced another setback in implementing their safe food policies in July 2017. A norovirus outbreak is being investigated in Virginia. More than 130 people reported having norovirus-like symptoms and two individuals had tested positive for the virus after eating at a Chipotle restaurant in Sterling, Virginia. The Loudoun County Health Department confirmed the illnesses from July 13–16, 2017. Shares of Chipotle stock dropped more than 10% on this news. On July 25, several news agencies reported that Chipotle officials confirmed that the "recent norovirus outbreak in Virginia was the result of lax sick policy enforcement by store managers" and that the company believed that an employee was the cause of the outbreak.
Street purity of 2C-B, when tested, has been found to be relatively high. Researchers in Spain found that 2C-B samples in the country doubled between 2006 and 2009, switched from primarily powder form to tablets, and exhibited "low falsification rates". An analysis of street samples in the Netherlands found impurities "in small percentages"; only one of the impurities, the N-acetyl derivative of 2C-B, could be identified, and comprised 1.3% of the sample. The authors suggested that this compound was a by-product of 2C-B synthesis. In 2011, street prices in the United States ranged between $10 and $30 per tablet when purchased in small quantities. Larger retail purchases cost between $200 and $500 per gram. Wholesale purchases of 2C-B would lower the price ($100 to $300 per gram in 2001, $30 to $100 on the darknet in 2020).
This amalgam was then heated in an atmosphere of hydrogen gas to remove the mercury, leaving pure radium metal. Later that same year, E. Ebler isolated radium metal by thermal decomposition of its azide, Ra(N3)2. Radium metal was first industrially produced at the beginning of the 20th century by Biraco, a subsidiary company of Union Minière du Haut Katanga (UMHK) in its Olen plant in Belgium. The metal became an important export of Belgium from 1922 up until World War II. The general historical unit for radioactivity, the curie, is based on the radioactivity of 226Ra. It was originally defined as the radioactivity of one gram of radium-226, but the definition was later refined to be 3.7×1010 disintegrations per second.
Sources: en.wikipedia.org
It measures the presence and amount of one or more compounds in a liquid sample. Separation occurs in a column, and detection produces a signal proportional to concentration. Identification usually requires comparison with a known reference standard under the same conditions.
In most cases the sample is consumed or altered during analysis, though some detectors are non-destructive. Fractions can be collected after separation for further study. Repeated testing therefore requires additional sample.
Run times range from under a minute for fast methods to over an hour for complex separations. Sample preparation, equilibration, and data review add time. Throughput depends on instrument configuration and method requirements.
It is a set of checks performed before or during an HPLC run to confirm the system works as expected. Parameters may include resolution, tailing factor, theoretical plates, and retention time precision. Failure can trigger maintenance, method adjustment, or repeat analysis.