This is a working overview of HPLC, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2025-12-01. Anything still debated is marked as such rather than presented as settled.
Method validation establishes that an HPLC procedure is suitable for its intended purpose. Typical parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, robustness, and solution stability. Accuracy reflects closeness to a reference value, while precision reflects agreement among repeated measurements. Specificity shows whether the method can measure the analyte without interference from matrix components. Validation is documented through protocols and reports, and the required extent depends on the method's use and regulatory context.
Routine quality control uses system suitability, blank injections, check standards, and control samples to detect drift or contamination. System suitability criteria may specify minimum resolution, maximum tailing factor, and a permitted range for repeated injections. Blank injections reveal carryover or solvent contamination, while check standards confirm calibration accuracy over a batch. Control samples with known analyte levels can show whether results remain within statistical limits. When a control result falls outside limits, the analyst investigates the cause and may invalidate affected results before repeating the batch.
Documentation and traceability are central to regulated HPLC testing. Records typically include instrument logs, column history, mobile-phase preparation, sample preparation, injection sequences, raw chromatograms, and audit trails. Electronic systems may require user access controls, time-stamped changes, and backup procedures. Training records show that analysts are qualified for assigned methods. Audits and inspections check whether written procedures match actual practice and whether deviations are documented. These controls support reproducibility and allow results to be reconstructed if questions arise later.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample by passing them through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in how analytes partition between the mobile phase and the stationary phase cause them to exit the column at different times. Detection then records a signal proportional to the amount of each separated substance. The resulting chromatogram provides retention times and peak areas for identification and quantification.
Instrumentation includes a solvent delivery system, an autosampler, a column oven, and one or more detectors. Reversed-phase columns with chemically modified silica are widely used, but normal-phase, ion-exchange, size-exclusion, and affinity modes exist for specific separations. Detectors may rely on ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry. Column temperature, mobile phase composition, and flow rate are adjusted to improve resolution. System pressure is monitored because rising pressure can indicate column blockage or deteriorating packing.
Separation performance depends on particle size, pore size, column length, and the chemistry of the stationary phase. Smaller particles generally improve efficiency but require higher pressure and suitable instrumentation. The mobile phase often contains buffers and organic solvents that influence retention and selectivity. Testing labs select conditions based on the analytes, sample matrix, and required sensitivity. Method development frequently involves screening several columns and solvent mixtures before a final set of conditions is chosen.
| Property | Value | Notes |
|---|---|---|
| Accuracy | Recovery near 100% | Depends on acceptance criteria and matrix |
| Precision | Relative standard deviation | Often at or below 2% for replicate injections |
| Limit of detection | Signal-to-noise ratio 3:1 | Approximate and method-specific |
| Limit of quantitation | Signal-to-noise ratio 10:1 | Confirmed by precision and accuracy |
| Resolution | 1.5 or greater | Typical system suitability target |
In quality control laboratories, HPLC testing supports batch release, raw material checks, stability studies, and impurity profiling. A validated method defines sample preparation, instrument settings, calibration, and acceptance criteria. Analysts compare results with specifications and investigate out-of-specification outcomes before a batch is approved. Documentation includes chromatograms, integration records, audit trails, and reagent details. Because results influence product decisions, laboratories follow formal quality systems and data integrity rules. The exact tests and limits depend on the material, its intended use, and the applicable regulatory framework.
Method validation examines whether an HPLC procedure is suitable for its intended purpose. Common parameters include accuracy, precision, specificity, linearity, range, detection limit, quantification limit, and robustness. Accuracy describes closeness to a true or accepted value, while precision describes agreement among repeated measurements. Specificity shows whether the method can measure the analyte without interference from related substances. Robustness tests small deliberate changes in flow, temperature, or solvent composition. Validation is not a one-time event; methods may need partial revalidation after changes to instruments, columns, sample handling, or specification limits. Regulatory guidance provides frameworks, but some details remain method-specific.
Obsidian is also used for ornamental purposes and as a gemstone. It presents a different appearance depending on how it is cut: in one direction it is jet black, while in another it is glistening gray. "Apache tears" are small rounded obsidian nuggets often embedded within a grayish-white perlite matrix. Plinths for audio turntables have been made of obsidian since the 1970s, such as the grayish-black SH-10B3 plinth by Technics.
oxidized rubredoxin + NAD(P)H + H+ The 3 substrates of this enzyme are reduced rubredoxin, NAD+, and NADP+, whereas its 4 products are oxidized rubredoxin, NADH, NADPH, and H+. This enzyme belongs to the family of oxidoreductases, specifically those acting on iron-sulfur proteins as donor with NAD+ or NADP+ as acceptor. The systematic name of this enzyme class is rubredoxin:NAD(P)+ oxidoreductase. Other names in common use include rubredoxin-nicotinamide adenine dinucleotide (phosphate) reductase, rubredoxin-nicotinamide adenine, dinucleotide phosphate reductase, NAD(P)+-rubredoxin oxidoreductase, and NAD(P)H-rubredoxin oxidoreductase. This enzyme participates in fatty acid metabolism.
The hydrophobic effect is the observed tendency of nonpolar substances to aggregate in an aqueous solution and to be excluded by water. The word hydrophobic literally means "water-fearing", and it describes the segregation of water and nonpolar substances, which maximizes the entropy of water and minimizes the area of contact between water and nonpolar molecules. In terms of thermodynamics, the hydrophobic effect is the free energy change of water surrounding a solute. A positive free energy change of the surrounding solvent indicates hydrophobicity, whereas a negative free energy change implies hydrophilicity. The hydrophobic effect is responsible for the separation of a mixture of oil and water into its two components. It is also responsible for effects related to biology, including: cell membrane and vesicle formation, protein folding, insertion of membrane proteins into the nonpolar lipid environment and protein-small molecule associations. Hence the hydrophobic effect is essential to life. Substances for which this effect is observed are known as hydrophobes.
Sources: en.wikipedia.org
Systemic lupus erythematosus (SLE) Systemic sclerosis Polymyositis Dermatomyositis Rheumatoid arthritis (RA) Sjögren's syndrome Eosinophilic granulomatosis with polyangiitis (EGPA) Autoimmune thyroiditis Antiphospholipid antibody syndrome The treatment of overlapping connective tissue disorders is mainly based on the use of corticosteroids and immunosuppressants. Biologic drugs, i.e. anti-TNFα or anti-CD20 monoclonal antibodies, have been recently introduced as alternative treatments in refractory cases. There are some concerns with the use of anti-TNF agents in patients with systemic autoimmune diseases due to the risk of triggering disease exacerbations. The term polyangiitis overlap syndrome refers to a systemic vasculitis that shares features with two or more distinct vasculitis syndromes. The most common type of polyangiitis overlap syndrome is microscopic polyangiitis (MPA), which shares features with EGPA, granulomatosis with polyangiitis and panarteritis nodosa. Sometimes polyangiitis overlap syndrome is used as a synonym for MPA.
=== Acoustic droplet ejection === Acoustic droplet ejection (ADE) uses a pulse of ultrasound to move low volumes of fluids (typically nanoliters or picoliters) without any physical contact. This technology focuses acoustic energy into a fluid sample to eject droplets as small as a millionth of a millionth of a litre (picoliter = 10−12 litre). ADE technology is a very gentle process, and it can be used to transfer proteins, high molecular weight DNA and live cells without damage or loss of viability. This feature makes the technology suitable for a wide variety of applications including proteomics and cell-based assays.
In 2013, Xi announced the Belt and Road Initiative (BRI), a global infrastructure and economic development project. Encompassing much of Africa and Eurasia, the BRI became central to Chinese foreign policy and is the largest infrastructure investment by a great power since the Marshall Plan. In 2015, Xi announced the founding of the Asia Infrastructure Investment Bank, seen as a competitor to other multilateral banks such as the World Bank and the Asia Development Bank. Xi has unveiled the Global Development Initiative (GDI), the Global Security Initiative (GSI), the Global Civilisation Initiative (GCI), and the Global Governance Initiative (GGI) in 2021, 2022, 2023 and 2025 respectively, aiming to increase China's influence in the international order. Under Xi, China has, along with Russia, also focused on increasing relations with the Global South in order to blunt the effect of international sanctions.
Sources: en.wikipedia.org
Winter describes a hula prayer for inspiration that contains the line, He ʻike pū ʻawa hiwa. Pukui and Elbert translated this as "a knowledge from kava offerings". Winter explains that ʻawa, especially of the Hiwa variety, was offered to hula deities in return for knowledge and inspiration. More recently, specialized kava varieties have been introduced to South Florida which have been acclimated and adapted to grow well in South Florida's unique soil and climate and have significant resistance to pest and disease pressures. As of 2024, cultivation of these varieties is limited to a small number of commercial farms and backyard growers.
== January 14, 1982 (Thursday) == An Ethiopian Air Force Antonov An-26 crashed near Addis Ababa, Ethiopia while transporting a group of Ethiopian, Libyan and Cuban soldiers to a fight in Eritrea. All 73 occupants on board were killed. It the state of Hidalgo in Mexico, near the town of Atotonilco de Tula, the bodies of 13 men were found by a drainage canal. The dead men would be found to have been from Colombia, who had been arrested, as well as a Mexican taxicab driver who had helped transport them to the scene of the deaths. Mexico City Police Chief Arturo Durazo Moreno, accused by a subordinate of having planned the killings, would end up fleeing Mexico after the inauguration of a new president. Robert Dale Henderson began a spree of mostly random murders that would kill 12 people across five U.S. states, in a little more than three weeks until his arrest on February 6, starting with a beautician in Cincinnati. One week later, on January 21, he murdered a family of three in Cherry Fork, Ohio, followed by the January 24 killing of a receptionist in Charleston, South Carolina, the January 25 homicides of a doctor and a clerk in Palatka, Florida and a mother and daughter later in the day in Valdosta, Georgia. He killed a nightclub owner in Port Allen, Louisiana on January 29, and three hitchhikers in Hernando County, Florida on February 4, before approaching a deputy sheriff at a shopping center in Punta Gorda, Florida, making a confession, and surrendering.
McKenna found Ari and Chloe's reunion to be "very emotional" and thought it was obvious that they have "a good relationship". She called Ari "a pretty decent guy" and "smooth" for telling Mac about Chloe and Mia. McKenna thought Mac and Ari's break-up was sad, but also obvious to everyone, writing "We all saw the breakup coming but after everything Mac has done for the Parata's — she even gave them her Porsche as drug collateral — it cuts real deep and it's another heartbreak for Home and Away." She later admonished Ari for his actions, writing "Oh Ari, we expected so much better from you. Ari literally left Mac and moved his old girlfriend in immediately and he's somehow surprised that she can't handle the sight of him?" Digital Spy's Susannah Alexander and Daniel Kilkelly believed the serial "lost a solid couple" in Ari and Mac and that fans of the pair were "upset to see them go their separate ways." After Ari and Mia learned they were expecting a baby, Stephen Downie of TV Week stated "If any couple deserves some happiness, it's Ari and Mia". McKenna later labelled Ari's final storyline "heart wrenching" and his wedding to Mia "bittersweet". Entertainment Daily's Steven Murphy said Ari's death "left viewers distraught" and was "a real shock" to those who had no idea Kipa-Williams was leaving the show. He also wrote "The demise was certainly dramatic. But it left many viewers wondering why Home and Away had killed off one of its most popular characters."
Sources: en.wikipedia.org
Validation establishes suitability for a new method, while verification confirms that a method works in a specific laboratory. Verification is often used when a validated method is adopted with existing equipment and staff. Both rely on documented acceptance criteria.
Quantification usually compares detector response to a standard curve made from reference standards. The curve may be external, internal, or based on standard addition depending on matrix effects. Results are reported with units and, when required, uncertainty.
Carryover occurs when analyte from a previous injection remains in the system and appears in a later chromatogram. It can come from the injector, column, or tubing. Blank injections and needle washes help detect and reduce it.
HPLC separates and detects individual compounds in a liquid sample, producing peaks at characteristic retention times. Peak area or height can be used to estimate concentration when calibrated with known standards. It does not identify unknown compounds with certainty unless additional detectors or reference materials are used.