If you have been reading about stationary phase and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2026-02-24. Numbers and descriptions here follow the published literature rather than marketing material.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. A diode array detector records full spectra across a wavelength range, which helps identify co-eluting peaks. Mass spectrometry provides mass-to-charge ratios and can confirm molecular identity at low concentrations. The choice of detector depends on analyte structure, required sensitivity, and whether quantitation or identification is the goal. No single detector works for every compound, and method development often compares responses before selecting one.
High-performance liquid chromatography is an analytical technique that separates components of a liquid sample by passing it through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in interaction with the stationary phase cause analytes to migrate at different rates. Detectors record elution as peaks, and a data system converts signals into a chromatogram. The method is suited to compounds that dissolve in a liquid and are not volatile enough for gas chromatography.
Reversed-phase chromatography dominates modern HPLC testing, using a nonpolar stationary phase such as chemically bonded octadecyl groups and a polar mobile phase of water mixed with organic solvent. Analytes partition between the mobile and stationary phases according to hydrophobicity. Gradient elution changes the mobile phase composition over time to separate compounds with a wide range of retention. Isocratic elution keeps the composition constant and is simpler for routine assays. Column temperature, pH, and flow rate influence selectivity, peak shape, and retention time, so these parameters are controlled during a validated method.
Routine HPLC testing compares a sample result with a calibration curve prepared from known reference standards. Peak area or peak height is plotted against concentration, and the curve is used to estimate unknown amounts. Retention time supports tentative identification when compared with a standard, though mass spectrometry or another confirmatory method may be needed for definitive identification. Pre-run checks verify repeatability, resolution, and peak symmetry before sample analysis. Limits of detection and quantification describe the smallest amounts that can be reliably observed or measured. Sample preparation, filtration, and degassing help prevent column damage and inconsistent results.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample. A pump moves a liquid mobile phase through a column packed with a solid stationary phase. Compounds interact differently with both phases and travel at different rates, leaving the column at distinct retention times. A detector records these arrivals as peaks on a chromatogram. The resulting pattern supports identification and quantification of substances in mixtures. Modern instruments use high pressure to force solvent through small particles, which improves speed and resolution compared with older low-pressure liquid chromatography methods.
| Property | Value | Notes |
|---|---|---|
| Separation mode | Reversed-phase | Most common for neutral and moderately polar analytes |
| Column particle size | 3–5 µm | Smaller particles improve resolution but raise backpressure |
| Mobile phase pH range | 2–8 | Silica-based columns may degrade outside this range |
| Typical flow rate | 1.0–2.0 mL/min | For analytical columns with 4.6 mm internal diameter |
| Common synonyms | HPLC, LC, high-pressure liquid chromatography | High-performance liquid chromatography is the standard expansion |
Most routine HPLC testing uses reversed-phase columns, where the stationary phase is nonpolar and the mobile phase is a polar mixture such as water with an organic solvent. Analytes partition between the two phases according to polarity, size, and charge. Gradients that change solvent composition over time can separate compounds with broad retention ranges. Isocratic conditions keep solvent composition constant and suit simpler mixtures. The choice of column chemistry, pH, and temperature affects selectivity and peak shape.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. UV detection is widely used because many organic compounds absorb light, but it requires a chromophore. Mass spectrometry provides mass-based identification and high sensitivity for trace analytes. Each detector has trade-offs in selectivity, cost, and compatibility with mobile phases. Quantification typically uses calibration curves prepared from reference standards. Results are reported as concentration, purity, or presence above a limit.
HPLC testing separates dissolved compounds by passing a liquid sample through a column packed with stationary phase. A pump delivers mobile phase at controlled flow, and the sample components interact differently with stationary and mobile phases. Compounds that spend more time in mobile phase elute earlier; those retained by stationary phase elute later. Detectors record elution as peaks, and peak area or height relates to amount. This mechanism underpins quantitative analysis of mixtures.
HPLC testing is an analytical technique used to separate, identify, and quantify components in a liquid sample. It relies on a pressurized mobile phase that carries the sample through a column packed with stationary phase. Different compounds travel at different rates because of interactions with the stationary and mobile phases. The resulting signal versus time is a chromatogram. Peak position indicates identity under specified conditions, while peak area or height relates to amount.
Laboratories apply HPLC testing across pharmaceutical, food, environmental, and industrial chemistry. The method can measure active ingredients, impurities, additives, preservatives, and degradation products. Sample preparation often includes dilution, filtration, and sometimes extraction or derivatization. The choice of column, mobile phase, pH, temperature, and detector depends on the analytes and matrix. Results are compared with reference standards to assign identity and concentration. Method suitability is judged by resolution, precision, and accuracy.
The soybean oil emulsion does not harm normal human cells, or the cells of most other higher organisms, with the exceptions of sperm cells and blood cells, which are vulnerable to nanoemulsions due to the peculiarities of their membrane structures. For this reason, these nanoemulsions are not used intravenously (IV). The most effective application of this type of nanoemulsion is for the disinfecting of surfaces. Some types of nanoemulsion have been shown to effectively destroy HIV-1 and tuberculosis pathogens on non-porous surfaces.
== Instrumentation == In the selected ion flow tube mass spectrometer, SIFT-MS, ions are generated in a microwave plasma ion source, usually from a mixture of laboratory air and water vapor. From the formed plasma, a single ionic species is selected using a quadrupole mass filter to act as "precursor ions" (also frequently referred to as primary or reagent ions in SIFT-MS and other processes involving chemical ionization). In SIFT-MS analyses, H3O+, NO+ and O2+ are used as precursor ions, and these have been chosen because they are known not to react significantly with the major components of air (nitrogen, oxygen, etc.), but can react with many of the very low level (trace) gases. The selected precursor ions are injected into a flowing carrier gas (usually helium at a pressure of 1 Torr) via a Venturi orifice (~1 mm diameter) where they travel along the reaction flow tube by convection. Concurrently, the neutral analyte molecules of a sample vapor enter the flow tube, via a heated sampling tube, where they meet the precursor ions and may undergo chemical ionization, depending on their chemical properties, such as their proton affinity or ionization energy. The newly formed "product ions" flow into the mass spectrometer chamber, which contains a second quadrupole mass filter, and an electron multiplier detector, which are used to separate the ions by their mass-to-charge ratios (m/z) and measure the count rates of the ions in the desired m/z range.
K is the clearance [mL/min] CU is the urine concentration [mmol/L] (in the USA often [mg/mL]) Q is the urine flow (volume/time) [mL/min] (often [mL/24 h]) CB is the plasma concentration [mmol/L] (in the USA often [mg/mL]) When the substance "C" is creatinine, an endogenous chemical that is excreted only by filtration, the clearance is an approximation of the glomerular filtration rate. Inulin clearance is less commonly used to precisely determine glomerular filtration rate. Note - the above equation (11) is valid only for the steady-state condition. If the substance being cleared is not at a constant plasma concentration (i.e. not at steady-state) K must be obtained from the (full) solution of the differential equation (9).
== Prognosis == Individuals with BED often have a lower overall quality of life and face social difficulties. Early behavior changes can predict a full recovery for the future. Individuals who have BED commonly have other conditions such as depression, personality disorder, bipolar disorder, substance abuse, body dysmorphic disorder, kleptomania, irritable bowel syndrome, fibromyalgia, or an anxiety disorder. They may also have history of attempted suicide and reoccurring panic attacks. While people of a normal weight may overeat occasionally, an ongoing habit of consuming large amounts of food in a short period of time may ultimately lead to weight gain and obesity. The main physical health consequences of this type of eating disorder are brought on by the weight gain resulting from calorie-laden bingeing episodes. Mental and emotional consequences of binge eating disorder include social weight stigma and emotional loss of control. Up to 70% of individuals with BED may also be obese, and therefore obesity-associated morbidities such as high blood pressure and coronary artery disease, type 2 diabetes mellitus, gastrointestinal issues (e.g., gallbladder disease), high cholesterol levels, musculoskeletal problems and obstructive sleep apnea may also be present. One study found a 42% obesity rate in those who have received a BED diagnosis. Additionally, a higher morbid obesity prevalence was observed in this population compared to a population without eating disorders.
== Further development == Partition chromatography allowed further developments of column chromatography, and inspired new forms of chromatography such as countercurrent distribution, paper chromatography, and gas chromatography. Commercial counter-current distribution instruments were used for many important discoveries The introduction of paper chromatography was an important analytical technique which gave rise to thin-layer chromatography. Finally, gas-liquid chromatography, a fundamental technique in modern analytical chemistry, was described by Martin with coauthors A. T. James and G. Howard Smith in 1952. The stationary phase can be changed to change the separation characteristics. By chemically bonding alkane functional groups to silica gel, we obtain reversed-phase chromatography. In 1944, Lyman C. Craig accomplished the original goal of Martin and Synge: column chromatography with two free-flowing liquid phases.
Sources: en.wikipedia.org
One type of nanoparticle involves use of liposomes as drug molecule carriers. The diagram on the left shows a standard liposome. It has a phospholipid bilayer separating the interior from the exterior of the cell. Liposomes are composed of vesicular bilayers, lamellae, made of biocompatible and biodegradable lipids such as sphingomyelin, phosphatidylcholine, and glycerophospholipids. Cholesterol, a type of lipid, is also often incorporated in the lipid-nanoparticle formulation. Cholesterol can increase stability of a liposome and prevent leakage of a bilayer because its hydroxyl group can interact with the polar heads of the bilayer phospholipids. Liposomes have the potential to protect the drug from degradation, target sites for action, and reduce toxicity and adverse effects. Lipid nanoparticles can be manufactured by high pressure homogenization, a current method used to produce parenteral emulsions. This process can ultimately form a uniform dispersion of small droplets in a fluid substance by subdividing particles until the desired consistency is acquired. This manufacturing process is already scaled and in use in the food industry, which therefore makes it more appealing for researchers and for the drug delivery industry. Liposomes can also be functionalized by attaching various ligands on the surface to enhance brain-targeted delivery.
The Association of Biomolecular Resource Facilities (ABRF) is dedicated to advancing core and research biotechnology laboratories through research, communication, and education. ABRF members include over 2000 scientists representing 340 different core laboratories in 41 countries, including those in industry, government, academic and research institutions.
==== Cognitive behavioral therapy ==== Cognitive behavioral therapy (CBT) is a form of psychosocial intervention that systematically evaluates thoughts, feelings, and behaviors about a problem and works to develop coping strategies to work through those problems. This intervention has demonstrated success in many psychiatric conditions (e.g., depression) and substance use disorders (e.g., tobacco). The use of CBT alone for OUD has declined due to lack of efficacy, and many rely on medication therapy or medication therapy with CBT, since both were found to be more efficacious than CBT alone. CBT has been shown to be more successful in relapse prevention than treatment of ongoing drug use. It is particularly known for its durability.
The smallpox vaccine has also proven useful in preventing emergent infectious diseases caused by closely-related orthopoxviruses such as Mpox. Three specific smallpox vaccines have been approved in at least one country for Mpox prevention: MVA-BN, LC16m8, and ACAM2000. The Mpox vaccine is on the World Health Organization's List of Essential Medicines.
Sources: en.wikipedia.org
HPLC testing separates and quantifies components in a liquid sample. It is used to check identity, purity, concentration, or stability. The technique works best for compounds that dissolve and are not easily vaporized.
The pump maintains a steady flow rate and pressure, which keeps retention times reproducible. Pulsation or flow errors can shift peaks and distort quantitation. Modern pumps use feedback control to reduce these variations.
HPLC alone usually separates compounds but does not always identify them. Retention time matching with a known standard provides tentative identification. Coupling HPLC to mass spectrometry adds mass information that supports structural identification.
HPLC testing measures the presence and amount of one or more compounds in a liquid sample. It separates mixture components and records detector responses as peaks, which are compared with reference standards. Results are usually reported as concentrations or relative percentages.