retention time raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
Reviewed 2026-05-26. Anything still debated is marked as such rather than presented as settled.
Several separation modes exist, including reversed-phase, normal-phase, ion-exchange, size-exclusion, and hydrophilic interaction liquid chromatography. Reversed-phase uses a nonpolar stationary phase with a polar mobile phase and is widely applied to small organic molecules. Gradient elution changes mobile phase composition during the run, while isocratic elution keeps it constant. Column chemistry, particle size, temperature, flow rate, and mobile phase pH all influence retention and resolution. Method development selects conditions that separate analytes from matrix components and from each other.
Detection commonly uses ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. Ultraviolet detection depends on molecular chromophores that absorb light at specific wavelengths. Mass spectrometry provides mass information and sensitive quantification, often after electrospray ionization. Before sample batches, performance checks examine resolution, elution time repeatability, peak symmetry, and plate count. Matrix effects and co-elution remain recognized uncertainties; formal validation studies and orthogonal detection help address them. Detector choice depends on analyte properties and required sensitivity.
Developing an HPLC method begins with defining the purpose, such as quantifying a main component, measuring impurities, or confirming identity. Analysts select separation mode, column, mobile phase, detection, and sample preparation based on analyte properties and matrix. Experiments vary solvent strength, pH, buffer type, and temperature to achieve resolution between critical peaks. The goal is a robust method that produces reliable results across instruments and operators. Method development often involves trial runs and statistical optimization.
Validation demonstrates that a method is suitable for its intended use. Typical performance characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulators and standards organizations provide frameworks, but specific requirements depend on the application and jurisdiction. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, retention time repeatability, and sensitivity. A validated method is not permanently fixed; changes may require partial or full revalidation.
| Property | Value | Notes |
|---|---|---|
| Column particle size | 3–5 µm for conventional HPLC; sub-2 µm for UHPLC | Smaller particles increase backpressure and efficiency. |
| Typical flow rate | 0.5–2.0 mL/min for a 4.6 mm internal diameter column | Flow scales with column diameter and particle size. |
| UV detection wavelength | 190–400 nm | Selection depends on analyte chromophore. |
| Column temperature | 25–40 °C | Temperature affects retention, selectivity, and pressure. |
| Injection volume | 1–20 µL | Larger volumes may distort early-eluting peaks. |
Reversed-phase chromatography dominates modern HPLC testing, using a nonpolar stationary phase such as chemically bonded octadecyl groups and a polar mobile phase of water mixed with organic solvent. Analytes partition between the mobile and stationary phases according to hydrophobicity. Gradient elution changes the mobile phase composition over time to separate compounds with a wide range of retention. Isocratic elution keeps the composition constant and is simpler for routine assays. Column temperature, pH, and flow rate influence selectivity, peak shape, and retention time, so these parameters are controlled during a validated method.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. A diode array detector records full spectra across a wavelength range, which helps identify co-eluting peaks. Mass spectrometry provides mass-to-charge ratios and can confirm molecular identity at low concentrations. The choice of detector depends on analyte structure, required sensitivity, and whether quantitation or identification is the goal. No single detector works for every compound, and method development often compares responses before selecting one.
High-performance liquid chromatography is an analytical technique that separates components of a liquid sample by passing it through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in interaction with the stationary phase cause analytes to migrate at different rates. Detectors record elution as peaks, and a data system converts signals into a chromatogram. The method is suited to compounds that dissolve in a liquid and are not volatile enough for gas chromatography.
== Applications == There is almost no use for any isotope of einsteinium outside basic scientific research aiming at production of higher transuranium elements and superheavy elements. In 1955, mendelevium was synthesized by irradiating a target consisting of about 109 atoms of 253Es in the 60-inch cyclotron at Berkeley Laboratory. The resulting 253Es(α,n)256Md reaction yielded 17 atoms of the new element with the atomic number of 101. The rare isotope 254Es is favored for production of superheavy elements due to its large mass, relatively long half-life of 270 days, and availability in significant amounts of several micrograms. Hence 254Es was used as a target in the attempted synthesis of ununennium (element 119) in 1985 by bombarding it with calcium-48 ions at the superHILAC linear particle accelerator at Berkeley, California. No atoms were identified, setting an upper limit for the cross section of this reaction at 300 nanobarns.
Many of his reports, which he wrote primarily for the newspaper Frankfurter Allgemeine Zeitung, the news magazine Der Spiegel and the weekly newspaper Die Zeit, were also published in expanded versions as books, becoming bestsellers. In cooperation with the Avicenna relief organization founded by his father Djavad Kermani, Kermani initiated fundraising campaigns for aid projects in Aceh (Indonesia), Lesbos, Madagascar and Tigray after returning from his reporting trips. Kermani's books have been translated into numerous languages. In his public statements and speeches, Kermani regularly comments on issues of society, politics and religion. Jan-Werner Müller described him in the New York Review of Books as one of Germany's most thought-provoking intellectual voices. From 2009 to 2012, Kermani was a senior fellow at the Kulturwissenschaftliches Institut (KWI) Institute for Advanced Humanities Study in Essen. In 2009, he was appointed a corresponding member of the Akademie der Wissenschaften [Academy of Sciences] in Hamburg. In the summer semester of 2010, Kermani served as guest lecturer in poetics at the Goethe University Frankfurt, where he gave the Frankfurter Poetikvorlesungen [Frankfurt Poetics Lectures], which were later published as a book entitled Über den Zufall. Jean Paul, Hölderlin und der Roman, den ich schreibe [On Contingency: Jean Paul, Hölderlin, and the Novel I Am Writing]. In the winter semester of 2011/12, Kermani delivered the Göttingen Poetics Lecture series, and in 2014, the Mainz Poetics Lecture series.
== Collisional reaction interface (CRI) or mini-Collision/Reaction Cell == The proprietary collisional reaction interface (CRI) used in the Bruker ICP-MS Aurora M90 destroys interfering ions. These ions are removed by injecting a collisional gas (He), or a reactive gas (H2), or a mixture of the two, directly into the plasma as it flows through the skimmer cone and/or the sampler cone. Supplying the reactive/collisional gas into the tip of the skimmer cone induces extra collisions and reactions that destroy polyatomic ions in the passing plasma. Fundamentally CRI is a mini- Collision/Reaction Cell installed in front of the parabolic Ion Mirror optics.
Sources: en.wikipedia.org
People with HbA1c values at 64 mmol/mol or less should be provided additional testing to determine whether the HbA1c values are due to averaging out high blood glucose (hyperglycemia) with low blood glucose (hypoglycemia) or the HbA1c is more reflective of an elevated blood glucose that does not vary much throughout the day. Devices such as continuous blood glucose monitoring allow people with diabetes to determine their blood glucose levels on a continuous basis, testing every few minutes. Continuous use of blood glucose monitors is becoming more common, and the devices are covered by many health insurance plans, including Medicare in the United States. The supplies tend to be expensive, since the sensors must be changed at least every 2 weeks. Another useful test in determining if HbA1c values are due to wide variations of blood glucose throughout the day is 1,5-anhydroglucitol, also known as GlycoMark. GlycoMark reflects only the times that the person experiences hyperglycemia above 180 mg/dL over a two-week period. Concentrations of hemoglobin A1 (HbA1) are increased, both in diabetic patients and in patients with kidney failure, when measured by ion-exchange chromatography. The thiobarbituric acid method (a chemical method specific for the detection of glycation) shows that patients with kidney failure have values for glycated hemoglobin similar to those observed in normal subjects, suggesting that the high values in these patients are a result of binding of something other than glucose to hemoglobin.
Antigen presentation is the first step in educating the immune system to recognize new pathogens. To this end, antigen presenting cells expose protein fragments via MHC molecules to the immune system. Not all protein fragments bind, however, to the MHC molecules of a certain individual. Using mass spectrometry, the true spectrum of molecules presented to the immune system can be determined.
=== Meat packing and trade === Prior to 1882, the South Island of New Zealand had been experimenting with sowing grass and crossbreeding sheep, which immediately gave their farmers economic potential in the exportation of meat. In 1882, the first successful shipment of sheep carcasses was sent from Port Chalmers in Dunedin, New Zealand, to London. By the 1890s, the frozen meat trade became increasingly more profitable in New Zealand, especially in Canterbury, where 50% of exported sheep carcasses came from in 1900. It was not long before Canterbury meat was known for the highest quality, creating a demand for New Zealand meat around the world. In order to meet this new demand, the farmers improved their feed so sheep could be ready for the slaughter in only seven months. This new method of shipping led to an economic boom in New Zealand by the mid 1890s. In the United States, the Meat Inspection Act of 1891 was put in place in the United States because local butchers felt the refrigerated railcar system was unwholesome. When meat packing began to take off, consumers became nervous about the quality of the meat for consumption. Upton Sinclair's 1906 novel The Jungle brought negative attention to the meat packing industry, by drawing to light unsanitary working conditions and processing of diseased animals. The book caught the attention of President Theodore Roosevelt, and the 1906 Meat Inspection Act was put into place as an amendment to the Meat Inspection Act of 1891. This new act focused on the quality of the meat and environment it is processed in.
== Further reading == ABARE (2000). National Plantation Inventory, March, 2000. 4p. Anon. (1997). Timber markets, home and away: Australian growers capitalising on international demand. Pie, Newsletter of Australia's International and National Primary Industries and Energy (PIE) R&D Organisations. Volume 7 (Summer Issue): p14. Avramidis et al. (2023). Basics of wood drying. link: [1] In: Springer Handbook of Wood Science and Technology Bootle, K.R. (1994). Wood in Australia: Types, Properties and Uses. McGraw-Hill Book Company, Sydney. 443p. Desch, H.E. and Dinwoodie, J.M. (1996). Timber: Structure, Properties, Conversion and Use. 7th ed. Macmillan Press Ltd., London. 306p. Doe, P.D., Oliver, A.R. and Booker, J.D. (1994). A Non-Linear Strain and Moisture Content Model of Variable Hardwood Drying Schedules. Proc. 4th IUFRO International Wood Drying Conference, Rotorua, New Zealand. 203-210pp. Haque, M.N. (1997). The Chemical Modification of Wood with Acetic Anhydride. MSc Dissertation. The University of Wales, Bangor, UK. 99p. Hoadley, R. Bruce (2000). Understanding Wood: A Craftsman's Guide to Wood Technology (2nd. ed.). Taunton Press. ISBN 1-56158-358-8. Innes, T. (1996). Improving Seasoned Hardwood Timber Quality with Particular Reference to Collapse. PhD Thesis. University of Tasmania, Australia. 172p. Keey, R.B., Langrish, T.A.G. and Walker, J.C.F. (2000). Kiln-Drying of Lumber. Springer, Berlin. 326p. Kollmann, F.F.P. and Cote, W.A.J. (1968). Principles of Wood Science and Technology. I. Solid Wood. Springer-Verlag, New York. 592p. Kumar, S. (1994).
Sources: en.wikipedia.org
nuclease Any of a class of enzymes capable of cleaving phosphodiester bonds connecting adjacent nucleotides in a nucleic acid molecule (the opposite of a ligase). Nucleases may nick one strand or cut both strands of a duplex molecule, and may cleave randomly or at specific recognition sequences. They are ubiquitous and imperative for normal cellular function, and are also widely employed in laboratory techniques.
C6H5OH + Hg(O2CCH3)2 → C6H4(OH)–HgO2CCH3 + CH3CO2H C6H4(OH)–HgO2CCH3 + NaCl → C6H4(OH)–HgCl + NaO2CCH3 The first such reaction, including a mercuration of benzene itself, was first reported by Otto Dimroth in 1898.
=== Alternative concepts === During their research, Eigen and Schuster also considered types of protein and nucleotide coupling other than hypercycles. One such alternative was a model with one replicase that performed polymerase functionality and that was a translational product of one of the RNA matrices existing among the quasispecies. This RNA-dependent RNA polymerase catalysed the replication of sequences that had specific motifs recognized by this replicase. The other RNA matrices, or just one of their strands, provided translational products which had specific anticodons and were responsible for unique assignment and transportation of amino acids. Another concept devised by Eigen and Schuster was a model in which each RNA template's replication was catalysed by its own translational product; at the same time, this RNA template performed a transport function for one amino acid type. Existence of more than one such RNA template could make translation possible. Nevertheless, in both alternative concepts, the system will not survive due to the internal competition among its constituents. Even if none of the constituents of such a system is selectively favoured, which potentially allows coexistence of all of the coupled molecules, they are not able to coevolve and optimize their properties. In consequence, the system loses its internal stability and cannot live on. The reason for inability to survive is the lack of mutual control of constituent abundances.
Sources: en.wikipedia.org
HPLC separates and quantifies compounds in a liquid sample. Detectors produce a response proportional to the amount of a compound passing through the flow cell. Identification by retention time requires comparison with a known standard.
UHPLC uses columns with smaller particles and operates at higher pressures than conventional HPLC. These conditions can improve speed, resolution, and sensitivity. Both techniques use the same fundamental separation principles.
Validation shows that a method performs reliably for its intended purpose across a defined range. It assesses accuracy, precision, specificity, linearity, and robustness. Regulated testing often requires documented validation before routine use.
It is a set of checks performed before or during an HPLC run to confirm the system works as expected. Parameters may include resolution, tailing factor, theoretical plates, and retention time precision. Failure can trigger maintenance, method adjustment, or repeat analysis.