The short version of retention time fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-07-30 and is reviewed periodically as new material appears.
Routine quality control uses system suitability, blank injections, check standards, and control samples to detect drift or contamination. System suitability criteria may specify minimum resolution, maximum tailing factor, and a permitted range for repeated injections. Blank injections reveal carryover or solvent contamination, while check standards confirm calibration accuracy over a batch. Control samples with known analyte levels can show whether results remain within statistical limits. When a control result falls outside limits, the analyst investigates the cause and may invalidate affected results before repeating the batch.
Documentation and traceability are central to regulated HPLC testing. Records typically include instrument logs, column history, mobile-phase preparation, sample preparation, injection sequences, raw chromatograms, and audit trails. Electronic systems may require user access controls, time-stamped changes, and backup procedures. Training records show that analysts are qualified for assigned methods. Audits and inspections check whether written procedures match actual practice and whether deviations are documented. These controls support reproducibility and allow results to be reconstructed if questions arise later.
Method validation establishes that an HPLC procedure is suitable for its intended purpose. Typical parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, robustness, and solution stability. Accuracy reflects closeness to a reference value, while precision reflects agreement among repeated measurements. Specificity shows whether the method can measure the analyte without interference from matrix components. Validation is documented through protocols and reports, and the required extent depends on the method's use and regulatory context.
Developing an HPLC method begins with defining the purpose, such as quantifying a main component, measuring impurities, or confirming identity. Analysts select separation mode, column, mobile phase, detection, and sample preparation based on analyte properties and matrix. Experiments vary solvent strength, pH, buffer type, and temperature to achieve resolution between critical peaks. The goal is a robust method that produces reliable results across instruments and operators. Method development often involves trial runs and statistical optimization.
Validation demonstrates that a method is suitable for its intended use. Typical performance characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulators and standards organizations provide frameworks, but specific requirements depend on the application and jurisdiction. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, retention time repeatability, and sensitivity. A validated method is not permanently fixed; changes may require partial or full revalidation.
Routine HPLC testing depends on controlled reagents, calibrated instruments, and documented procedures. Columns degrade over time, so retention times and peak shapes are monitored for drift. Mobile phases are filtered and degassed to prevent pump damage and detector noise. Reference standards must be traceable and stored under suitable conditions. Data handling systems record injections, calculations, and audit trails. Quality control samples interspersed with unknowns help detect errors during a run.
| Property | Value | Notes |
|---|---|---|
| Accuracy | Recovery near 100% | Depends on acceptance criteria and matrix |
| Precision | Relative standard deviation | Often at or below 2% for replicate injections |
| Limit of detection | Signal-to-noise ratio 3:1 | Approximate and method-specific |
| Limit of quantitation | Signal-to-noise ratio 10:1 | Confirmed by precision and accuracy |
| Resolution | 1.5 or greater | Typical system suitability target |
High-performance liquid chromatography testing separates components of a liquid sample by forcing a mobile phase through a packed column. The stationary phase inside the column interacts with analytes to different degrees, so each compound exits at a characteristic retention time. A pump delivers solvent at controlled flow and pressure, while an injector introduces a precise sample volume. Detectors such as ultraviolet-visible, fluorescence, refractive index, or mass spectrometric instruments record the separated bands. The resulting chromatogram provides qualitative and quantitative information about the mixture.
Separation modes differ by the chemistry of the stationary phase and the composition of the mobile phase. Reversed-phase testing uses a nonpolar column and polar solvents, making it common for pharmaceutical, environmental, and food analytes. Normal-phase testing uses a polar column and nonpolar solvents for compounds that are poorly retained in reversed-phase systems. Ion-exchange and ion-pair methods separate charged species, while size-exclusion methods sort molecules by hydrodynamic volume. Gradient elution changes solvent strength over time to resolve complex mixtures, and isocratic elution holds solvent composition constant for simpler assays.
Key performance measures include retention time, peak area, peak height, resolution, tailing factor, and plate count. Retention time helps identify a peak under fixed conditions, but confirmation often requires a second method or detector. Peak area and height relate to concentration through calibration curves, which may be linear or nonlinear depending on the detector response. Resolution describes separation between adjacent peaks, while tailing factor and plate count describe peak shape and column efficiency. Performance checks verify these values before and during a run to confirm that the instrument is performing within limits.
HPLC testing separates dissolved compounds by passing a liquid sample through a column packed with stationary phase. A pump delivers mobile phase at controlled flow, and the sample components interact differently with stationary and mobile phases. Compounds that spend more time in mobile phase elute earlier; those retained by stationary phase elute later. Detectors record elution as peaks, and peak area or height relates to amount. This mechanism underpins quantitative analysis of mixtures.
Most routine HPLC testing uses reversed-phase columns, where the stationary phase is nonpolar and the mobile phase is a polar mixture such as water with an organic solvent. Analytes partition between the two phases according to polarity, size, and charge. Gradients that change solvent composition over time can separate compounds with broad retention ranges. Isocratic conditions keep solvent composition constant and suit simpler mixtures. The choice of column chemistry, pH, and temperature affects selectivity and peak shape.
Method validation evaluates accuracy, precision, specificity, linearity, range, detection limit, quantitation limit, and robustness. Regulatory guidance for pharmaceuticals, foods, and environmental testing defines expected documentation and acceptance criteria. Verification confirms that a validated method works in a specific laboratory with its own instruments and reagents. Calibration curves use reference standards with known purity and traceability, while measurement uncertainty is estimated from validation data, control charts, and collaborative studies. The scope of validation depends on the method's intended use.
Routine quality control monitors retention time shifts, baseline noise, system pressure, and peak shape. Trends can reveal column aging, mobile phase preparation errors, detector drift, or sample degradation. Corrective actions may include replacing the column, preparing fresh mobile phase, or recalibrating the detector. Stability testing often uses HPLC to measure parent compound loss and degradation product formation. Open questions remain about how accelerated stability results extrapolate to long-term storage under varied conditions.
=== Brand names === Dutasteride is sold primarily under the brand name Avodart, but also in combination with tamsulosin under the brand names Combodart, Duodart, and Jalyn. Dutasteride is also available in India in combination with alfuzosin under the brand names Alfusin-D and Dutalfa.
=== Unknown date === Eight marine reservists were investigated for abuse and the death of a prisoner, outside Nasiriyah. A photograph leaked after the initial set shows Spc. Sabrina Harman smiling and giving a thumbs up next to the body of Manadel al-Jamadi. Jamadi was reportedly beaten to death during interrogations in the prison's showers. Death certificates repeatedly stated that prisoners had died "while sleeping", and of "natural reasons". Iraqi doctors are not allowed to investigate the deaths of prisoners, even if death certificates are allegedly forged. No investigations against US military doctors who are alleged to have forged death certificates have been reported.
=== NNPC Bags Transparency Award === The efforts of the Mallam Mele Kyari-led Management of the Nigerian National Petroleum Corporation (NNPC) to entrench the culture of transparency in the system have begun to receive recognition with the Corporation named as the “Government Agency of the Year 2020 (Transparency)” by the New Telegraph.
Sources: en.wikipedia.org
=== Sources === Print Bosco, David (2009). Five to Rule Them All: The UN Security Council and the Making of the Modern World. Oxford University Press. ISBN 978-0-19-532876-9. Dallek, Robert (1995). Franklin D. Roosevelt and American Foreign Policy, 1932–1945: With a New Afterword. Oxford University Press. ISBN 978-0-19-982666-7. Gaddis, John Lewis (1972). The United States and the Origins of the Cold War, 1941–1947. Columbia University Press. ISBN 978-0-231-12239-9. Hoopes, Townsend; Brinkley, Douglas (1997). FDR and the Creation of the U.N.. Yale University Press. ISBN 978-0-300-08553-2. Kimball, Warren F. (1991). The Juggler: Franklin Roosevelt as Wartime Statesman. Princeton University Press. ISBN 0-691-03730-2. Ma, Xiaohua (2003). The Sino-American alliance during World War II and the lifting of the Chinese exclusion acts. New York: Routledge. pp. 203–204. ISBN 0-415-94028-1. United States Department of State (1942). "Union of Soviet Socialist Republics". Foreign relations of the United States diplomatic papers, 1942. Europe Volume III. U.S. Government Printing Office. pp. 406–771. Welles, Sumner (January 1951). "Two Roosevelt Decisions: One Debit, One Credit". Foreign Affairs. Vol. 29, no. 2. pp. 182–204. Online "1942: Declaration of The United Nations". United Nations. Archived from the original on May 13, 2016. Retrieved April 21, 2016. "1945: The San Francisco Conference". United Nations. 1945. Archived from the original on October 30, 2015. Retrieved May 16, 2015. Urquhart, Brian (July 16, 1998). "Looking for the Sheriff". New York Review of Books.
Salmon farms are typically sited in pristine coastal ecosystems which they then pollute. A farm with 200,000 salmon discharges more fecal waste than a city of 60,000 people. This waste is discharged directly into the surrounding aquatic environment, untreated, often containing antibiotics and pesticides." There is also an accumulation of heavy metals on the benthos (seafloor) near the salmon farms, particularly copper and zinc. In 2016, mass fish kill events impacted salmon farmers along Chile's coast and the wider ecology. Increases in aquaculture production and its associated effluent were considered to be possible contributing factors to fish and molluscan mortality. Sea cage aquaculture is responsible for nutrient enrichment of the waters in which they are established. This results from fish wastes and uneaten feed inputs. Elements of most concern are nitrogen and phosphorus which can promote algal growth, including harmful algal blooms which can be toxic to fish. Flushing times, current speeds, distance from the shore and water depth are important considerations when locating sea cages in order to minimize the impacts of nutrient enrichment on coastal ecosystems. The extent of the effects of pollution from sea-cage aquaculture varies depending on where the cages are located, which species are kept, how densely cages are stocked and what the fish are fed. Important species-specific variables include the species' food conversion ratio (FCR) and nitrogen retention.
== Binding between UII and URP == Since they are both ligands for the same receptor, an experiment was done to determine which ligand had a higher affinity. When the binding of the two were compared and tested, URP actually had higher affinity.
Sources: en.wikipedia.org
Planet Half-Life (often abbreviated to PHL) was a gaming website owned by IGN and its subsidiary GameSpy. Maintained by a voluntary team of contributors, the site was dedicated to providing news and information about Half-Life, Half-Life 2 and related modifications and other Valve titles. It was founded by Kevin "Fragmaster" Bowen and was at one point the largest of an array of GameSpy-run gaming websites known as the Planet Network. Following Glu Mobile's acquisition of GameSpy Industries, the Planet Network has ceased to work, and subsequently Planet Half-Life has fallen into disarray.
Early in embryonic development, the embryo has three germ layers and abuts a yolk sac. During the second week of development, the embryo grows and begins to surround and envelop portions of this sac. The enveloped portions form the basis for the adult gastrointestinal tract. Sections of this foregut begin to differentiate into the organs of the gastrointestinal tract, such as the esophagus, stomach, and intestines. During the fourth week of development, the stomach rotates. The stomach, originally lying in the midline of the embryo, rotates so that its body is on the left. This rotation also affects the part of the gastrointestinal tube immediately below the stomach, which will go on to become the duodenum. By the end of the fourth week, the developing duodenum begins to spout a small outpouching on its right side, the hepatic diverticulum, which will go on to become the biliary tree. Just below this is a second outpouching, known as the cystic diverticulum, that will eventually develop into the gallbladder.
=== Energy expenditure === The Na+/K+-ATPase is an active enzyme. It uses energy from ATP to move ions against their concentration gradient. In fact, all cells expend a large fraction of the ATP they produce (typically 30% and up to 70% in nerve cells) to maintain their required cytosolic Na and K concentrations. For neurons, the Na+/K+-ATPase can be responsible for up to three-fourths of the cell's energy expenditure. In many types of tissue, ATP consumption by the Na+/K+-ATPases have been related to glycolysis. This was first discovered in red blood cells (Schrier, 1966), but has later been evidenced in renal cells, smooth muscles surrounding the blood vessels, and cardiac cells which compose Purkinje fibers. Recently, glycolysis has also been shown to be of particular importance for Na+/K+-ATPase in skeletal muscles, where inhibition of glycogen breakdown (a substrate for glycolysis) leads to reduced Na+/K+-ATPase activity and lower force production.
Sources: en.wikipedia.org
Validation establishes suitability for a new method, while verification confirms that a method works in a specific laboratory. Verification is often used when a validated method is adopted with existing equipment and staff. Both rely on documented acceptance criteria.
Quantification usually compares detector response to a standard curve made from reference standards. The curve may be external, internal, or based on standard addition depending on matrix effects. Results are reported with units and, when required, uncertainty.
Carryover occurs when analyte from a previous injection remains in the system and appears in a later chromatogram. It can come from the injector, column, or tubing. Blank injections and needle washes help detect and reduce it.
It is a set of checks performed before or during an HPLC run to confirm the system works as expected. Parameters may include resolution, tailing factor, theoretical plates, and retention time precision. Failure can trigger maintenance, method adjustment, or repeat analysis.