retention time is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2026-04-24. Where a claim depends on a specific study, the study is described rather than over-claimed.
Practical HPLC testing depends on careful sample preparation and instrument maintenance. Samples may require filtration, dilution, pH adjustment, or extraction to avoid column damage and matrix interference. Mobile phases are degassed and filtered, and columns are equilibrated before injection. Common problems include peak tailing, baseline drift, ghost peaks, carryover, and co-elution of analytes. Documentation of instrument logs, calibration records, and electronic audit trails supports data integrity and traceability. Ongoing training and routine maintenance help reduce variability between analysts and laboratories.
Quality control laboratories use HPLC to check identity, purity, concentration, and stability of raw materials and finished products. A validated method specifies the column, mobile phase, flow rate, detection wavelength, injection volume, and run time. Samples are prepared and compared against reference standards of known concentration. The resulting chromatogram provides quantitative data, such as assay values and impurity levels. This approach is common in pharmaceutical, food, environmental, and industrial testing where consistent measurements are required.
Method validation demonstrates that an analytical procedure is suitable for its intended purpose. Typical validation characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulatory guidance from bodies such as the International Council for Harmonisation and the United States Pharmacopeia outlines expectations, though specific criteria depend on the product and method. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, column efficiency, and injection repeatability. Failure of these checks can invalidate a batch of measurements.
Reversed-phase chromatography dominates modern HPLC testing, using a nonpolar stationary phase such as chemically bonded octadecyl groups and a polar mobile phase of water mixed with organic solvent. Analytes partition between the mobile and stationary phases according to hydrophobicity. Gradient elution changes the mobile phase composition over time to separate compounds with a wide range of retention. Isocratic elution keeps the composition constant and is simpler for routine assays. Column temperature, pH, and flow rate influence selectivity, peak shape, and retention time, so these parameters are controlled during a validated method.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. A diode array detector records full spectra across a wavelength range, which helps identify co-eluting peaks. Mass spectrometry provides mass-to-charge ratios and can confirm molecular identity at low concentrations. The choice of detector depends on analyte structure, required sensitivity, and whether quantitation or identification is the goal. No single detector works for every compound, and method development often compares responses before selecting one.
| Parameter | Typical acceptance criterion | Notes |
|---|---|---|
| Resolution | ≥ 1.5 | Baseline separation of adjacent peaks |
| Tailing factor | ≤ 2.0 | Peak symmetry measure |
| Theoretical plates | > 2000 | Column efficiency indicator |
| Injection repeatability | ≤ 2% RSD | Relative standard deviation for replicate injections |
| Linearity | r² ≥ 0.995 | Calibration curve over the working range |
Data handling and documentation are central to HPLC quality control. Electronic systems should have audit trails that record changes to methods, sequences, and results. Integration parameters, such as peak baseline and threshold, can affect reported areas and must be defined in advance. Out-of-specification results trigger a structured investigation that may include reanalysis, instrument checks, and review of sample preparation. Regulatory inspections often examine raw data, audit trails, and training records to verify that reported results are traceable and reliable.
Method validation establishes that an HPLC procedure is suitable for its intended use. Key parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Accuracy measures agreement with a true or accepted value, while precision describes repeatability and intermediate precision. Specificity confirms that the method measures the analyte without interference from impurities, degradants, or excipients. Validation is documented in a protocol and report, and acceptance criteria are set before experiments begin. Regulatory guidance varies by region, but the general principles are widely harmonized.
Separation in HPLC depends on the chemistry of the stationary phase, the composition of the mobile phase, and the physical properties of the column. Reverse-phase separations use a nonpolar stationary phase and a polar mobile phase, and they are common for many organic compounds. Ion-exchange, size-exclusion, and normal-phase modes serve other classes of analytes. Gradient elution changes solvent strength over time, while isocratic elution holds it constant. Flow rate, temperature, particle size, and column length all influence peak shape and resolution. Detection may use ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry, depending on the analyte and the required sensitivity.
Routine HPLC testing compares a sample result with a calibration curve prepared from known reference standards. Peak area or peak height is plotted against concentration, and the curve is used to estimate unknown amounts. Retention time supports tentative identification when compared with a standard, though mass spectrometry or another confirmatory method may be needed for definitive identification. Pre-run checks verify repeatability, resolution, and peak symmetry before sample analysis. Limits of detection and quantification describe the smallest amounts that can be reliably observed or measured. Sample preparation, filtration, and degassing help prevent column damage and inconsistent results.
== Drug interactions == Loperamide is a substrate of P-glycoprotein; therefore, the concentration of loperamide increases when given with a P-glycoprotein inhibitor. Common P-glycoprotein inhibitors include quinidine, ritonavir, and ketoconazole. Loperamide can decrease the absorption of some other drugs. As an example, saquinavir concentrations can decrease by half when given with loperamide. Loperamide is an antidiarrheal agent, which decreases intestinal movement. As such, when combined with other antimotility drugs, the risk of constipation is increased. These drugs include other opioids, antihistamines, antipsychotics, and anticholinergics.
=== Legal status === On 28 January 2021, the Committee for Medicinal Products for Human Use (CHMP) of the European Medicines Agency (EMA) adopted a positive opinion, recommending the granting of a marketing authorization for the medicinal product Byfavo, intended for procedural sedation. The applicant for this medicinal product is PAION Netherlands B.V. Remimazolam (Byfavo) was approved for medical use in the European Union in March 2021.
Serotonin is known to regulate aging, learning, and memory. The first evidence comes from the study of longevity in C. elegans. During early phase of aging, the level of serotonin increases, which alters locomotory behaviors and associative memory. The effect is restored by mutations and drugs (including mianserin and methiothepin) that inhibit serotonin receptors. The observation does not contradict with the notion that the serotonin level goes down in mammals and humans, which is typically seen in late but not early phase of aging.
== References == Mesa MG, Duarte HÁ, Carretero JH, López MM, Vilas MM (May 2011). "De Marco Formula effectiveness as an adjunctive therapy to prevent infected ischemic diabetic foot amputation and reduce plasma fibrinogen". J Tissue Viability. 20 (2): 67–72. doi:10.1016/j.jtv.2010.12.003. PMID 21211975. Alvarez Duarte H, Fors López MM, Carretero JH, Vilas MM, García Mesa M (August 2010). "Tolerability and safety of conventional therapy combination with DeMarco formula for infected ischemic diabetic foot". J Tissue Viability. 19 (3): 116–22. doi:10.1016/j.jtv.2010.03.002. PMID 20570516. Mahia Vilas M, Hernández Carretero J, García Mesa M, Álvarez Duarte H, Valdés Pérez C, De Marco LG. (2010) "Microalbuminuria and immune system in patients with infected ischemic diabetic foot treated with De Marco Formula." Span. J. Surg. Res, Vol. XIII, Num. 1, (12–16), Año 2010. Miriam Mahía Vilas; Héctor T. Álvarez Duarte; José G. Hernández Carretero; Milagros García Mesa; María Eugenia Triana Mantilla; Alicia Rodríguez Pérez. "Utilidad de la fórmula De Marco en pacientes diabéticos con complicaciones vasculares y su acción inmunomoduladora sobre la función de los linfocitos T. (Usefulness of De Marco formula in diabetic patients suffering vascular complications and its immunomodulating action on the T lymphocyte function.)" [1] Revista Cubana de Angiología y Cirugía Vascular. 2008; 9(1) Duarte HA, Fernández Montequín JI, Fors López MM, Carretero JH, Vilas MM, Mesa MG. Duarte HA, Fernández Montequín JI, Fors López MM, Carretero JH, Vilas MM, Mesa MG (2009).
Sources: en.wikipedia.org
== See also == Cantonese salted fish Cured fish Salted squid Dried and salted cod Brining Gibbing Pickling salt Spekesild (cured, salted Atlantic herring) Surströmming (lightly-salted soured Baltic herring)
Died: Henri Gaudier-Brzeska, 23, French artist and sculptor, member of the Vorticism movement; killed in action at Neuville-Saint-Vaast (b. 1891) John C. Rice, 58, American actor, best known for performing the first onscreen kiss with May Irwin in 1896 for the Thomas Edison film The Kiss; died of Bright's disease (b. 1857)
tandem repeat A pattern within a nucleic acid sequence in which one or more nucleobases are repeated and the repetitions are directly adjacent (i.e. tandem) to each other. An example is ATGACATGACATGAC, in which the sequence ATGAC is repeated three times.
Carbon nanotubes are used in multiple industrial and consumer applications. These include battery components, polymer composites, to improve the mechanical, thermal and electrical properties of the bulk product, and as a highly absorptive black paint. Many other applications are under development, including field effect transistors for electronics, high-strength fabrics and biosensors for biomedical and agricultural applications.
==== Dame Commander of the Order of the British Empire (DBE) ==== Civil Dr Margaret Ebunoluwa Aderin, , Chancellor, University of Leicester. For services to Science Education and to Diversity. Amanda Jayne Blanc, Group Chief Executive Officer, Aviva. For services to Business, to Gender Equality and to Net-Zero. Professor Sonia Boyce, , Artist. For services to Art. Jilly Cooper, , Author. For services to Literature and to Charity. Felicity Ann Dahl, Founder, Roald Dahl's Marvellous Children's Charity and the Roald Dahl Museum and Story Centre. For services to Philanthropy, to Literature and to Young People. Dr Jennifer Dixon, , Chief Executive, The Health Foundation. For services to the NHS and to Public Health. Tristina Adele Harrison, Chief Executive Officer, TalkTalk Group. For services to Telecommunications. Dianne Michèle Jeffrey, , lately Trustee and Founder Chair, Age International. For services to Older People Abroad and to the community in Derbyshire. Professor Valerie Joan Lund, , Emeritus Professor in Rhinology, University College London. For services to Rhinology. Siobhain Ann McDonagh, , Member of Parliament for Mitcham and Morden. For Parliamentary and Political Service. Ruth Elizabeth Miskin, , Children's Reading Expert, Read Write Inc. For services to Education. Marit Mohn, Philanthropist. For services to Philanthropy. Professor Molly Morag Stevens, , John Black Professor of Bionanoscience, University of Oxford and Professor, Imperial College London. For services to Medicine.
Sources: en.wikipedia.org
Per CLIA, each specific laboratory system, assay, examination is graded for level of complexity by assigning scores of 1, 2, or 3 for each of the following seven criteria. A score of 1 is the lowest level of complexity, and a score of 3 is the highest. Score 2 is assigned when the characteristics for a particular test are intermediate between the descriptions listed for scores of 1 and 3. Criteria for categorization:
C13H9−CH2−OC(O)NHR + (CH2)5NH → (CH2)5NH+2 + [C13H8−CH2−OC(O)NHR]− [C13H8−CH2−OC(O)NHR]− → C13H8=CH2 + −OC(O)NHR −OC(O)NHR + (CH2)5NH+2 → HOC(O)NHR + (CH2)5NH HOC(O)NHR → CO2 + RNH2 C13H8=CH2 + (CH2)5NH → C13H9−CH2N(CH2)5
An additional study published in 2020 by Woodward and colleagues, for the journal Science Advances indicates that during their growth from juvenile to adult, Tyrannosaurus was capable of slowing down its growth to counter environmental factors such as lack of food. Based on BMRP 2002.4.1 and BMRP 2006.4.4 between 13 and 15 years old housed at the Burpee Museum in Illinois then referred to as juvenile Tyrannosaurus specimens, the authors suggested that the rate of maturation for Tyrannosaurus was dependent on resource abundance. This study also indicates that in such changing environments, Tyrannosaurus was particularly well-suited to an environment that shifted yearly in regards to resource abundance, hinting that other midsize predators might have had difficulty surviving in such harsh conditions and explaining the niche partitioning between juvenile and adult tyrannosaurs. The study further suggested that Tyrannosaurus and Nanotyrannus are synonymous, due to analysis of the growth rings in the bones of the two specimens studied. In January 2026, Woodward, Myhrvold and Horner performed a comprehensive histological analysis of 17 tyrannosaur specimens, and argued that Tyrannosaurus likely experienced a more gradual annual growth rate slope than indicated by earlier studies and evidence of a protracted subadult stage, reaching asymptotic size at around 35–40 years of age. The upper limit of the annual growth rate estimate is approximately 43–53 years.
In 2006, only about 2% of college student athletes in the United States used HMB as a dietary supplement. As of 2017, HMB has reportedly found widespread use as an ergogenic supplement among young athletes.
Sources: en.wikipedia.org
Method validation is the documented process of confirming that an HPLC procedure is suitable for its intended use. It evaluates accuracy, precision, specificity, linearity, range, detection limits, and robustness. Validation criteria depend on the regulatory context and the sample type.
System suitability tests are short checks performed before or during an HPLC run to verify instrument and method performance. They often include resolution, tailing factor, theoretical plates, and injection precision. Results must meet predefined limits for sample data to be accepted.
HPLC retention time alone cannot definitively identify an unknown substance. A match with a reference standard under identical conditions provides supporting evidence. Confirmation typically requires mass spectrometry, nuclear magnetic resonance, or another orthogonal technique.
HPLC testing separates and quantifies components in a liquid sample. It is used to check identity, purity, concentration, or stability. The technique works best for compounds that dissolve and are not easily vaporized.