If you have been reading about retention time and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2025-08-20. Where a claim depends on a specific study, the study is described rather than over-claimed.
Method validation establishes that an HPLC procedure is suitable for its intended use. Key parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Accuracy measures agreement with a true or accepted value, while precision describes repeatability and intermediate precision. Specificity confirms that the method measures the analyte without interference from impurities, degradants, or excipients. Validation is documented in a protocol and report, and acceptance criteria are set before experiments begin. Regulatory guidance varies by region, but the general principles are widely harmonized.
System suitability testing is performed before and during analytical runs to confirm that the instrument and method are working as expected. Common checks include retention time, peak area, resolution between critical pairs, tailing factor, and theoretical plate count. Results are compared with predefined limits, and a failed check requires investigation before sample results are reported. Quality control samples at low, middle, and high concentrations are injected at intervals to monitor accuracy and precision. Blank injections detect carryover and contamination, while control charts track performance over time.
High-performance liquid chromatography is an analytical technique that separates components of a liquid sample by passing it through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in interaction with the stationary phase cause analytes to migrate at different rates. Detectors record elution as peaks, and a data system converts signals into a chromatogram. The method is suited to compounds that dissolve in a liquid and are not volatile enough for gas chromatography.
Reversed-phase chromatography dominates modern HPLC testing, using a nonpolar stationary phase such as chemically bonded octadecyl groups and a polar mobile phase of water mixed with organic solvent. Analytes partition between the mobile and stationary phases according to hydrophobicity. Gradient elution changes the mobile phase composition over time to separate compounds with a wide range of retention. Isocratic elution keeps the composition constant and is simpler for routine assays. Column temperature, pH, and flow rate influence selectivity, peak shape, and retention time, so these parameters are controlled during a validated method.
| Property | Value | Notes |
|---|---|---|
| Validation parameter | Accuracy | Measured value compared with true or accepted value |
| Precision type | Repeatability | Same analyst, instrument, and short time interval |
| Linearity range | 50–150% of target concentration | Common for assay methods; method-dependent |
| Limit of quantitation | Signal-to-noise ratio of 10:1 | Lowest concentration with acceptable precision |
| Common synonyms | Method validation, analytical validation | Documented confirmation that a method is suitable |
Method validation demonstrates that an analytical procedure is suitable for its intended purpose. Typical validation characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulatory guidance from bodies such as the International Council for Harmonisation and the United States Pharmacopeia outlines expectations, though specific criteria depend on the product and method. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, column efficiency, and injection repeatability. Failure of these checks can invalidate a batch of measurements.
Practical HPLC testing depends on careful sample preparation and instrument maintenance. Samples may require filtration, dilution, pH adjustment, or extraction to avoid column damage and matrix interference. Mobile phases are degassed and filtered, and columns are equilibrated before injection. Common problems include peak tailing, baseline drift, ghost peaks, carryover, and co-elution of analytes. Documentation of instrument logs, calibration records, and electronic audit trails supports data integrity and traceability. Ongoing training and routine maintenance help reduce variability between analysts and laboratories.
Method validation establishes that an HPLC procedure is suitable for its intended purpose. Typical parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, robustness, and solution stability. Accuracy reflects closeness to a reference value, while precision reflects agreement among repeated measurements. Specificity shows whether the method can measure the analyte without interference from matrix components. Validation is documented through protocols and reports, and the required extent depends on the method's use and regulatory context.
Routine quality control uses system suitability, blank injections, check standards, and control samples to detect drift or contamination. System suitability criteria may specify minimum resolution, maximum tailing factor, and a permitted range for repeated injections. Blank injections reveal carryover or solvent contamination, while check standards confirm calibration accuracy over a batch. Control samples with known analyte levels can show whether results remain within statistical limits. When a control result falls outside limits, the analyst investigates the cause and may invalidate affected results before repeating the batch.
Documentation and traceability are central to regulated HPLC testing. Records typically include instrument logs, column history, mobile-phase preparation, sample preparation, injection sequences, raw chromatograms, and audit trails. Electronic systems may require user access controls, time-stamped changes, and backup procedures. Training records show that analysts are qualified for assigned methods. Audits and inspections check whether written procedures match actual practice and whether deviations are documented. These controls support reproducibility and allow results to be reconstructed if questions arise later.
== Academic amateur diplomat == As an instructor at Harvard, Kissinger published his 1957 book Nuclear Weapons and Foreign Policy, whose popularity established his reputation as one of America's leading thinkers on foreign policy. Kissinger's involvement in Indochina started prior to his appointment as National Security Advisor to Nixon. While still at Harvard, he had worked as a consultant on foreign policy to both the White House and State Department. Kissinger says that "In August 1965 ... [Henry Cabot Lodge Jr.], an old friend serving as Ambassador to Saigon, had asked me to visit Vietnam as his consultant. I toured Vietnam first for two weeks in October and November 1965, again for about ten days in July 1966, and a third time for a few days in October 1966 ... Lodge gave me a free hand to look into any subject of my choice". He became convinced of the meaninglessness of military victories in Vietnam, "... unless they brought about a political reality that could survive our ultimate withdrawal". Lodge allowed Kissinger to go anywhere he wanted, and to meet the ruling duumvirate of Air Marshal Nguyễn Cao Kỳ and General Nguyễn Văn Thiệu. In a gaffe, Kissinger spoke frankly to an American reporter, Jack Foisie, who had arrived late to the press conference and was not aware that the press conference was "off-the-record". Kissinger called both Air Marshal Kỳ and General Thiệu immature men of low intelligence, remarks that Foise published and which drew the ire of President Lyndon B. Johnson.
TMA is isothermal, meaning it is performed at constant temperature. As such, a water bath or heat block can be used instead of a thermal cycler. TMA produces RNA amplicon rather than DNA amplicon. Since RNA is more labile in a laboratory environment, this reduces the possibility of carry-over contamination. TMA produces 100–1000 copies per cycle (PCR and LCR exponentially doubles each cycle). This results in a 10 billion fold increase of DNA (or RNA) copies within about 15–30 minutes.
Other analgesics work peripherally (i.e., not on the brain or spinal cord). Research is starting to show that morphine and related drugs may indeed have peripheral effects as well, such as morphine gel working on burns. Recent investigations discovered opioid receptors on peripheral sensory neurons. A significant fraction (up to 60%) of opioid analgesia can be mediated by such peripheral opioid receptors, particularly in inflammatory conditions such as arthritis, traumatic or surgical pain. Inflammatory pain is also blunted by endogenous opioid peptides activating peripheral opioid receptors. It was discovered in 1953, that humans and some animals naturally produce minute amounts of morphine, codeine, and possibly some of their simpler derivatives like heroin and dihydromorphine, in addition to endogenous opioid peptides. Some bacteria are capable of producing some semi-synthetic opioids such as hydromorphone and hydrocodone when living in a solution containing morphine or codeine respectively. Many of the alkaloids and other derivatives of the opium poppy are not opioids or narcotics; the best example is the smooth-muscle relaxant papaverine. Noscapine is a marginal case as it does have CNS effects but not necessarily similar to morphine, and it is probably in a category all its own.
Sources: en.wikipedia.org
The Rockefeller Foundation continued funding German eugenics research even after it was clear that it was being used to rationalize discrimination against Jewish people and other groups, after the Nuremberg laws in 1935. In 1936, Rockefeller fulfilled pledges of $655,000 to Kaiser Wilhelm Institute, even though several distinguished Jewish scientists had been dropped from the institute at the time. The Rockefeller Foundation did not alert the world about the racist implications of Nazi ideology, but furthered and funded eugenic research through the 1930s. Even into the 1950s, Rockefeller continued to provide some funding for research borne out of German eugenics. The foundation also funded the relocation of scholars threatened by the Nazis to America in the 1930s, known as the Refugee Scholar Program and the Emergency Committee in Aid of Displaced Foreign Scholars. Some of the notable figures relocated or saved, among a total of 303 scholars, were Thomas Mann, Claude Lévi-Strauss and Leó Szilárd. The foundation helped The New School provide a haven for scholars threatened by the Nazis.
microRNA (miRNA) A type of small, single-stranded, non-coding RNA molecule that functions in post-transcriptional regulation of gene expression, particularly RNA silencing, by base-pairing with complementary sequences in mRNA transcripts, which typically results in the cleavage or destabilization of the transcript or inhibits its translation by ribosomes.
The pancreatic islets or islets of Langerhans are the regions of the pancreas that contain its endocrine cells (hormone-producing cells), discovered in 1869 by German pathological anatomist Paul Langerhans. The pancreatic islets constitute 1–2% of the pancreas volume and receive 10–15% of its blood flow. The pancreatic islets are arranged in density routes throughout the human pancreas, and are important in the metabolism of glucose.
There are six autonomous public universities in Singapore, including National University of Singapore founded in 1905, Nanyang Technological University founded 1981, Singapore Management University founded in 2000, Singapore University of Technology and Design and Singapore Institute of Technology founded in 2009, and Singapore University of Social Sciences founded in 2017.
Sources: en.wikipedia.org
System suitability is a set of checks that confirm the instrument and method perform within limits before sample analysis. It typically includes resolution, tailing factor, retention time, and peak area reproducibility. If a check fails, the run is invalidated until the cause is resolved.
QC samples are usually injected at the beginning, at intervals during the run, and at the end. The exact frequency depends on the method, sample count, and regulatory requirements. Results outside acceptance limits can require rejection of the affected samples and investigation.
Method validation demonstrates that an HPLC procedure produces reliable results for its intended purpose. It provides documented evidence for accuracy, precision, specificity, and other performance characteristics. Regulators and quality systems require validation before a method is used for release or stability testing.
HPLC testing separates and quantifies components in a liquid sample. It is used to check identity, purity, concentration, or stability. The technique works best for compounds that dissolve and are not easily vaporized.